I installed plex server from the dev2day sourceon an asus tinkerboard.
The installation armf went well but I have some problem during the native transcoding (with ARM was heating the proc and planted during the construction of the db).
I explain the problem: The playback of videos hangs natively in wifi or lan about 30 sec of reading, however the same video on the pi3 starts without any problem.
I tried several parameters in the plex configuration interface (and also the same ones as the pi3).
But when I change the playback quality during the video on a transcoding in less than 1 mbits, the video reads
Could you help me?
PS: As a reminder, the tinker board is 2GB of ram, the network card is gigabyte and wifi and the processor is an ARM Cortex-A17 Quad @ 1.8 GHz SoC Rockchip RK3288 that decodes native H264 and H265.
It's a basic 32 bit but I noticed that it runs better on 64 bit
Tank you all