Welcome to our forums! Please take a few moments to read through our Community Guidelines (also conveniently linked in the header at the top of each page). There, you'll find guidelines on conduct, tips on getting the help you may be searching for, and more!

PUBLISHING SERVER

dmacewen@nyc.rr.comdmacewen@nyc.rr.com Posts: 6Members, Plex Pass
CANNOT PUBLISH SERVER TO MYPLEX
When I try to publish server to MyPlex, this is the response I get: "Failed to map to ports: not an IGD device. There was an error publishing the connection." If I try doing it manually, I get this response: "Server is mapped to port 32400. MyPlex was unable to connect to your server." So I logged into my router and enabled port forwarding. I entered 32400 under Start Port and End Port. I set the IP address. I chose UDP for protocol, then checked Enable. However, I'm still getting the same message when I try to publish my server to myPlex. Does anyone know what I'm doing wrong?

Comments

  • TrudgeTrudge Gone off to greener pastures.... Posts: 9,360Members ✭✭✭

    When I try to publish server to MyPlex, this is the response I get: "Failed to map to ports: not an IGD device. There was an error publishing the connection." If I try doing it manually, I get this response: "Server is mapped to port 32400. MyPlex was unable to connect to your server." So I logged into my router and enabled port forwarding. I entered 32400 under Start Port and End Port. I set the IP address. I chose UDP for protocol, then checked Enable. However, I'm still getting the same message when I try to publish my server to myPlex. Does anyone know what I'm doing wrong?

    Hi,

    1) Just enabling UDP is not enough, you need to also enable TCP
    2) Make sure your PC filewall is also configured to allow the connection
    3) Make sure you ISP supplied modem is not also acting as a router - it will need to be configured to work in bridge or modem mode if it is.

    http://wiki.plexapp.com/index.php/MyPlex
Sign In or Register to comment.