Some backstory: My Western Digital NAS (EX4100, set to RAID5), unfortunately had TWO of the FOUR drives fail. Specifically 1 drive failed, replaced drive and started rebuild, 2nd drive failed with 10% left to complete rebuild. Any support from WD was useless. Had to go the extremely expensive data recovery service route. 100% of the data was recovered (movie files, as well as what seems to be NAS & PLEX folders that I would not have normally seen on the NAS - folders like “plex-conf”, & “plexmediaserver”, etc.).
Here is the question. I have to set up the RAID again from the beginning. I can easily add PLEX like I did initially, but is there a way to “rebuild” PLEX with all my original settings, collections, etc.? Or do I have to start that over as well?
Any recommendations?
Michelle
